3
FRONT PANEL
1. INPUT GAIN - Controls the Input level with +/- 12 dB of gain.
2. LOW CUT - Switch for selecting the 25 Hz high pass filter.
3. CROSSOVER FREQUENCY - Adjusts the frequencies for the
low and high bands.
4. DELAY - Provides a timing delay of up to 2 seconds for
the signal to reach the outputs, which is helpful to align
speaker systems in phase.
5. GAIN - Controls the frequencies output level with a range
of -∞ to +6 dB.
6. PHASE INVERT - Reverses the polarity of the output by
180 degrees to compensate for high-frequency
cancellation.
7. MUTE - Mutes the output of the selected frequency.
8. CD HORN - Compensates for the high-frequency roll-off in a CD (Constant Directivity)
Horn loudspeaker by providing the same sound pressure levels at frequencies above 3.5
kHz within the sound coverage area.
9. STEREO - LED indicating stereo mode operation.
10. THRESHOLD - Sets the point at which the Limiter will affect the signal.
11. MULTIBAND LIMITER – Activate this to prevent the signal from clipping.
12. POWER - Press this button to power AX2304 on/off.
REAR PANEL
1. POWER - Connect the included power cable here and then connect to a wall outlet.
2. FREQUENCY OUTPUT - Outputs for the various frequency bands.
3. XOVER FREQ X10 - When the X10 button is pressed on the rear panel, the frequency range is
multiplied by 10.
4. CHANNEL INPUT - Connect your source device here.
5. MODE - Select the mode to use to process each of the frequency bands.
6. LF - Select between having the low frequencies be in stereo or summed together in mono.
Commentaires sur ces manuels