Alto-professional AX2304 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 64
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
STEREO 2-WAY SETUP
Note: Be sure that the rear panel Mode switch is in the
correct position and that the corresponding connectors are
properly configured; otherwise, you could damage your
speakers.
1. Use the included power cable to connect AX2304 to
a wall outlet.
2. Connect the source from your mixer’s output to the input of Channels 1 and 2 on AX2304.
3. Connect the High Output from Channels 1 and 2 of AX2304 to the audio inputs on your amplifier.
4. Connect the Low Output from Channels 1 and 2 of AX2304 to the audio inputs on your amplifier.
5. *Adjust the Mode buttons so that the left Mode button is depressed and the right button is raised.
6. In Stereo Mode, the two low frequency paths can be combined and sent to the Low Output of Channel
1. Depress the LF Sum button and then connect the LF Sum output of Channel 1 to your system. This
feature is useful when a single sub is in the system.
7. *Use the Xover Freq button to adjust the control range of the front panel Low/High from 44 Hz to 930
Hz or from 440 Hz to 9.3 kHz.
8. Power up AX2304 before your power amplifier. When powering off, turn off the power amplifier first,
then turn off AX2304.
*WARNING: Power off your speakers
before pressing the XOVER FREQ button
and the Mode buttons. A loud burst of
noise will be sent, which can damage
speakers.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

Commentaires sur ces manuels

Pas de commentaire