Alto-professional Radius 200 Manuel d'utilisateur télécharger pdf (Page 6)

Belt-Pack Transmitter (for Radius 200H headset, Radius 200L lavalier microphone, or

Radius 200M instrument cable)

1. Power/Mute Button: Press this button for 2 seconds to power

the transmitter on or off. Press this button briefly to mute or

unmute the transmitter.

2. Power/Mute LED: This light indicates the power or mute status:

• Red light: The transmitter is on.

• Flashing red light: The transmitter is low on battery

power.

• Blue light: The transmitter is muted.

• Flashing blue light: The transmitter is muted and low on

battery power.

3. Sync Button: Press this button to synchronize the transmitter

with the receiver. See Operation to learn more.

4. Display: This display shows the current channel and battery

power level.

5. Battery Compartment (not pictured): Insert 2 AA batteries into

this compartment. Make sure the polarities of the batteries (+ and

–) are correct.

6. Microphone/Instrument Input (mini-XLR): Connect the included

microphone or instrument cable to this input.

7. Gain Selector: Use this switch to set the gain of the audio input

to 10 dB, 0 dB, or -10 dB. For instruments with passive pickups,

we recommend setting this to -10 dB. For instruments with active

pickups, you may want to set this to 0 dB or -10 dB.

Receiver

Front Panel

POWER

1. Power Button: Press this button to power the receiver on or off.

2. Display: This display shows the current channel, frequency, and other settings. See Display for

more information.

3. Up/Down (): Press one of these buttons to select the different modes (Manual, Autoscan,

Preset). When searching for channels, press one of these buttons to move to the next-highest or

next-lowest channel, respectively.

4. Sync: Press this button to synchronize the receiver with the transmitter. See Operation to learn

more.

5. Set: Press this button to confirm your mode selection (Manual, Autoscan, Preset) or to set the

current channel. See Operation to learn more.

6. Volume Knob: Turn this knob to adjust the receiver’s output level.

1: Ground

2: Line In

3: Mic In

4: +10V

1: Ground

2: Line In

3: Mic In

4: +10V

Mic Level

Line Level

3 4 1

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Alto-professional Radius 200 Manuel d'utilisateur Page 6

Commentaires sur ces manuels