Alto-professional Radius 200 Manuel d'utilisateur télécharger pdf (Page 9)

Set Up the Receiver’s Connections, Mode, and Channel

1. Use the included power adapter to connect the receiver's power input to your power source.

The receiver will power on automatically.

2. Use a standard XLR cable or 1/4” (6.35mm) to connect one of the receiver’s audio outputs to

your mixer or amplifier system. Do not use both audio outputs at the same time; this can result

in signal loss or increased noise.

3. Set the Line/Mic Selector to the appropriate setting:

• Set this switch to Line if you are connecting it to a balanced line-level input (e.g., a mixer’s

XLR or 1/4” (6.35mm) TRS input) or an instrument amplifier’s low-impedance active

instrument input.

• Set this switch to Mic if you are connecting it to an instrument amplifier’s high-impedance

instrument-level input.

4. Set the receiver’s channel using one of the following methods:

• Manual Mode

Important: Do not place two or more transmitters within range of the receiver when

selecting a channel. Also, keep the transmitter at least 3 feet (1 meter) away from the

receiver.

i. Use the receiver’s Up or Down buttons to select Manual Mode. (You must press

and hold each button for approximately 1 second to switch to the next mode.)

ii. Press and hold the Set button for approximately 1 second. The display’s numbers

will flash.

iii. Use the Up/Down buttons to select a channel.

iv. Press the Set button to lock the reception to that channel.

• Autoscan Mode

Important: If you are setting up a system using multiple receiver-transmitter pairs, keep

each pair powered on as you set up others. This will prevent each pair from automatically

selecting the same channel.

i. Use the receiver’s Up or Down buttons to select Autoscan Mode (Auto). (You

must press and hold each button for approximately 1 second to switch to the next

mode.)

ii. Press and hold the Set button for approximately 1 second. The display’s numbers

will flash.

iii. Press the Up or Down button once. The receiver will automatically scan

frequencies and select the first channel with strong, clear reception.

iv. Press the Set button to lock the reception to that channel.

• Preset Mode

i. Use the receiver’s Up or Down buttons to select Preset Mode. (You must press

and hold each button for approximately 1 second to switch to the next mode.)

ii. Press and hold the Set button for approximately 1 second. The display’s numbers

will flash.

iii. Use the Up/Down buttons to select a Preset group (P1, P2, P3, or P4).

iv. Press the Set button to lock the reception to that Preset group.

v. Use the Up/Down buttons to select a channel in that Preset group.

vi. Press the Set button to lock the reception to a channel in that Preset group.

Important: If there is any interference on the current Preset group’s channels, repeat

Steps iii–vi.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Alto-professional Radius 200 Manuel d'utilisateur Page 9

Commentaires sur ces manuels