Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur télécharger pdf (Page 4)

Transmitter Features

Note: Transmitters are not included in the Stealth Wireless Expander Pack, only with the Stealth

Wireless base model. One transmitter can be used to send audio to many receiver units.

Rear Panel

1. Antennas – Place the antennas in a vertical position for best

results in transmitting the wireless signal. If the wireless signal

quality is poor, change the position of the antennas.

2. Combo Inputs – Connect balanced or unbalanced 1/4” or XLR

line-level sources here.

3. Power Connector – Connect the included 12V DC, 300 mA power

adapter here.

Front Panel

1. Power Button – Press this button to turn the

transmitter on/off.

2. Mono/Stereo Select – Adjust this switch to

change the wireless signal that is sent to the

receiver to be either mono/stereo.

3. Signal Clip Indicator – The LED will turn red when the signal is close to peaking (clipping).

Note: The LED will begin to flicker red at -4 dB before clipping and become solid red if clipping

occurs.

4. Channel Select – Adjusts the frequency band range.

• Match channels on the transmitter and receiver in order to get a signal.

• Watch the receiver’s AF indicator and RF indicator to make sure a signal is being received.

• If you receive interference, change to another channel until a clean signal comes through.

• To change the channel:

a. Press and hold the Channel Select button for approximately 1 second until the

channel number flashes.

b. While the channel number is flashing, tap the Channel Select button to cycle through

the 16 available channels. Set the transmitter and receiver(s) to the same channel.

c. When the desired channel number is shown, wait for 3 seconds. When the channel

number stops flashing, that channel is now selected.

d. Use the Left/Right Selector switches to set which receiver receives the left and right

signals, since the left and right signals are sent on the same channel.

5. Trim – Adjusts the signal level.

POWER MONO/ STEREO

MIN MAX MIN MAX

CHANNEL

2 2

1 2 3 4 5 6 7 8 9 ... 39 40

Pas de commentaire

Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur Page 4