Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur télécharger pdf (Page 5)

Receiver Features

Bottom Panel

1. Output – Connect this XLR output to the input of your speaker.

2. Power – Connect the included 12V DC, 300 mA power supply here.

Front Panel

1. Antenna – The wireless receiver’s 2 antennas receive the signal that is

sent from the transmitter. Place the antennas in a vertical position for the

best signal quality.

2. AF Indicator – When illuminated, this LED indicates that an audio signal is

being detected by the receiver. If this LED does not turn on, check your

power connection and channel settings and try again.

3. RF Indicator – When illuminated, this LED indicates that the receiver is

receiving a signal. If this LED does not turn on, check your power

connection and channel settings and try again.

4. Power Indicator – When illuminated, this LED indicates the unit is

powered on.

5. Channel Select – To change the channel:

a. Press and hold the Channel Select button for approximately 1 second until the channel

number flashes.

b. While the channel number is flashing, tap the Channel Select button to cycle through the

16 available channels. Set the transmitter and receiver(s) to the same channel.

c. When the desired channel number is shown, wait for 3 seconds. When the channel

number stops flashing, that channel is now selected.

d. Use the Left/Right Selector switches to set which receiver receives the left and right

signals, since the left and right signals are sent on the same channel.

6. Power Button – Press this button to turn on the receiver.

Side Panel

1. Left/Right Selector – Selects which stereo channel the receiver receives from the

transmitter. This only applies if both receivers are being used in a stereo application.

On both receivers, set the switch to the appropriate positions that match the L/R

speaker configuration. The Trim controls are directly connected to the L/R receiver

settings.

2. Squelch – Sets a noise limit. Signals must come in above that noise limit in order to

pass through the squelch filter. There are three settings to choose from depending

on how much noise there is. Set this switch to the position that most effectively

eliminates noise while allowing the signal to come through.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Pas de commentaire

Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur Page 5