Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur télécharger pdf (Page 6)

Connection Diagrams

Single Channel Setup

To send mono signals through the Stealth Wireless transmitter to a single receiver:

1. Connect your mixer’s main output to an input on the Stealth Wireless transmitter, and connect the

receiver’s output to your loudspeaker’s input. Keep all mixer volume and transmitter Trim controls

their minimum settings.

2. Power on the Stealth Wireless transmitter and receiver. Set their channels to matching numbers.

3. Adjust the transmitter and receiver antennas to a vertical position.

4. Set the transmitter to “mono” and adjust the Trim control to get a strong signal without clipping.

5. Turn on your loudspeaker, adjust the output level on your mixer, and adjust the Trim controls on

the transmitter to hear the audio signal. If you hear noise in the signal, change to a different

channel until a clean signal comes through.

Receiver

Powered

Speaker

Mixer

This diagram shows

the signal flow from a

mixer, through Stealth

Wireless, to a speaker.

Transmitter

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Pas de commentaire

Alto-professional Stealth Wireless Expander Pack Manuel d'utilisateur Page 6