Alto-professional iPA Music System Manuel d'utilisateur télécharger pdf (Page 2)

BOX CONTENTS

• iPA Music System

• Microphone

• Microphone cable (XLR)

• Power cable

• Quickstart Guide

• Safety Instructions & Warranty Information Booklet

QUICK SETUP

1. Connect iPA Music System's POWER INPUT to power outlet using the included power

cable. (Do not power on iPA Music System yet.)

2. Optional: Connect microphone to INPUT using standard XLR or 1/4" cable.

3. iPad (3rd generation) and iPad 2 users: Power on your iPad (not included). Slide it into

plastic "sled" and gently connect it to the DOCK connector.

iPad users: iPA Music System's plastic "sled" has a plastic "rail" on each side to

accommodate the new iPad and iPad 2, which are thinner. Use a screwdriver, your

thumbs, etc. to remove these rails before using it (see the illustrations here as well as in

the included Quickstart Guide poster). Power on your iPad (not included). Slide it into the

sled and gently connect it to the DOCK connector.

iPad 2

iPad

(

generatio n

)

iPad

4. Set both volume knobs (INPUT VOLUME and DOCK VOLUME) at minimum setting.

5. Turn iPA Music System's POWER SWITCH to ON.

6. Play music on iPad. Adjust DOCK VOLUME to a reasonable volume level. The

SIGNAL/PEAK LED will illuminate red.

7. Optional: Talk into microphone (if one is connected to INPUT). Adjust INPUT VOLUME to

reasonable volume level.

Note: You can connect an extension speaker (another iPA Music System, not

included) to the MIX OUT using a standard XLR cable. If you do this:

• So the extension speaker's playback level matches that of the main speaker,

set the extension speaker's INPUT VOLUME at the "9 o'clock" knob position.

• You can set which channel (left, right, or summed mono) is sent to your

extension speaker. See OUTPUT CHANNEL description under REAR PANEL

OVERVIEW for more information.

1 2 3 4 5 6 7 ... 19 20

Pas de commentaire

Alto-professional iPA Music System Manuel d'utilisateur Page 2