Alto-professional Trouper Manuel d'utilisateur télécharger pdf (Page 3)

Example 2: One Trouper loudspeaker system with vocal microphone and guitar with

active pickup:

Example 3: Two Trouper loudspeaker systems with remote mixer, DJ controller, etc.:

Connect a dynamic microphone to the Ch. 1

Input using an XLR or 1/4" (6.35 mm) TRS

cable. Connect a guitar with an active pickup

to the Ch. 2 Input using a 1/4" (6.35 mm) TS

cable.

Note: When using the Trouper loudspeaker

system with a guitar, we recommend using

one with active pickups rather than passive

pickups. If you use a guitar with passive

pickups, connect it to an external preamp or

direct input (DI) box, and connect the line-

level output to the loudspeaker.

We recommend using dynamic microphones

with the Trouper loudspeaker rather than

condenser microphones. If you use a

microphone that requires +48V of phantom

power, you must connect it to an external

phantom power supply. Trouper does not

supply any phantom power.

Microphone

Acoustic guitar

with active pickup

Power

DJ controller,

mixer, etc.

Connect the left and right output of your DJ

mixer, controller, etc. to Ch. 1 Input of each

loudspeaker system using XLR or 1/4" (6.35

mm) TRS cables.

Tip: To send the same mix to both Trouper

loudspeakers, connect both channels of your

DJ mixer, controller, etc. to the Ch. 1 and Ch.

2 Inputs of one loudspeaker, and then connect

that loudspeaker's Link Output to the Ch. 1

Input of the other loudspeaker. Both Trouper

loudspeaker systems will then play identical

summed mono mixes.

1 2 3 4 5 6 7 8 ... 39 40

Pas de commentaire

Alto-professional Trouper Manuel d'utilisateur Page 3