Alto-professional RMX1008DFX Manuel d'utilisateur télécharger pdf (Page 8)

With the AMPLIFIER MODE in MAIN+MONITOR position, OUTPUT 1 drives a Main speaker cabinet while OUTPUT

2 drives a stage monitor.

WARNING: In MAIN + MONITOR mode, the speaker loads of OUTPUT 1 and OUTPUT 2 cannot be less than 4 ohm,

or it will damage the unit.

With the AMPLIFIER MODE switch in BRIDGE position, the two power amplifiers in your RMX drive together a single

speaker cabinet with the sum of the power of the 2 amps. Usually this solution is used to drive a single subwoofer and

the MAIN OUT on the front panel is used to feed a pair of powered speakers as mid-high units.

WARNING: In bridged mode, it can only be connected with an 8 ohm speaker load, which is connected on the 2+ and

1+ terminals of OUTPUT2 speakon jack. The other speakon jacks and phone jacks cannot be connected with

speaker load, or it will damage the amplifier.

Main Speaker

MAIN + MONITOR Mode

Monitor

Use either the Speakon

jacks or 1/4" jacks

Monitor

Bridge Mode

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Pas de commentaire

Alto-professional RMX1008DFX Manuel d'utilisateur Page 8