Alto-professional Live 802 Manuel d'utilisateur télécharger pdf (Page 4)

Features

Top Panel

Note: The channels have essentially the same

controls with some minor variations between

Channels 1-2, 3-4, 5/6, and 7/8. The four

different channel types are shown here.

1. Mic Input: Connect a microphone or

line-level device to these inputs with an

XLR cable.

2. Line Input: Connect line-level devices to

these inputs with 1/4" cables.

3. Insert: Use a standard 1/4" TRS cable

to connect an external processor (such

as a compressor, limiter, external EQ

unit, etc.) to this jack. The signal will be

taken after the channel's gain control

and returned before the channel's EQ

controls. The tip of the TRS connection

is the send, and the ring is the return.

4. Gain: Adjusts the channel audio level

(pre-fader and pre-EQ gain). Adjust this

so that the Signal LED lights up.

5. Peak LED: The LED will flash if the

signal is clipping. If this happens,

decrease the setting of the Gain knob.

6. Low Cut Filter: When this button is

depressed, that channel's audio will be

sent through a 75 Hz low-frequency filter

with a slope of 18 dB per octave. This is

useful for reducing low-frequency noise

when using microphones.

7. Compressor: Adjusts the amount of

compression on the channel, applied by

the mixer's built-in compressor. The

LED next to the knob will light up when

the compressor is on.

8. Hi EQ: Adjusts the high (treble) frequencies of the channel.

9. Mid EQ: Adjusts the mid-range frequencies of the channel.

10. Low EQ: Adjusts the low (bass) frequencies of the channel.

11. Monitor Knob: Adjusts the pre-fader level of the signal sent from that channel to the

Monitor Mix, whose level is controlled by the Monitor Fader.

12. DFX Knob: Adjusts the post-fader level of the signal sent to the mixer's effects

processor, whose level is controlled by the DFX Return Fader (DFX Rtn).

13. Channel Pan / Balance: If this knob is labeled Pan, it adjusts the (mono) channel's

position in the stereo field. If the knob is labeled Bal, it adjusts the balance between the

left and right channels of that stereo signal.

14. Channel Mute: Press this button to mute/unmute the channel. The LED next to the

button will light up when the channel is muted.

15.

Channel Fader: Adjusts the audio level on the channel.

16. Signal LED (Sig): Indicates that the channel's incoming audio signal is within an optimal

range.

1 2 3 4 5 6 7 8 9 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Alto-professional Live 802 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Alto-professional Live 802