Alto-professional RMX1008DFX Manuel d'utilisateur télécharger pdf (Page 5)

REAR PANEL

35. POWER SWITCH – Turns the

mixer on and off. Turn on the

mixer after all input devices have

been connected and before you

turn on amplifiers. Turn off

amplifiers before you turn off the

mixer.

36. POWER IN – Use the included

IEC power cable to connect the

mixer to a power outlet. While the power

is switched off, plug the power supply into

the mixer first, then plug the power supply

into a power outlet. Please check the

voltage available in your country and how

the voltage for your RMX1008DFX is

configured before attempting to connect

your RMX1008DFX to the main AC.

37. SPEAKER JACKS- These jacks are used

to connect speakers. They are configured with 4-way Speakon connectors and 1/4" phone jacks. You

can determine the signal that is output to these jacks according to the setting of the AMPLIFIER MODE

select switch.

Note: In order to avoid damage to the built-in amplifier, please pay attention to the allowed

impedance of the speaker. Very low load impedances may damage the amplifier. Look at the

plate on the back of your unit for reference.

Caution: Do not connect the rear panel speaker level ¼” outputs to anything other than a passive

loudspeaker. Connecting this output to a line line/Mic level input may damage your equipment.

* WARNING: Units bought in the US are preset to

US voltage. Units purchased in EU/UK are preset

to 220/240 voltage. Adjustment should not be

made unless you’re traveling to other countries or

are in a country with varying voltage. Selecting an

improper voltage can damage the unit.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Pas de commentaire

Alto-professional RMX1008DFX Manuel d'utilisateur Page 5