Alto-professional MIXPACK Pro Manuel d'utilisateur télécharger pdf (Page 4)

FEATURES

AC100V ~ 50/60Hz

110 -120V ~ 50/60Hz

220 -240V ~ 50/60Hz

RATED POWER CONSUMPTION:1000W

T12 AL

T6.3 AL

NEW

1. POWER IN – Use the included power cable to connect the mixer to a power outlet. While the power is

switched off, plug the power cable into the mixer first, then plug the power cable into a power outlet.

2. VOLTAGE SELECTOR – This 2-position switch sets the AC input voltage for the speaker. The switch

should already be set to the correct voltage for your location. (US users should set this switch to "100-

120V" whereas UK and most European users will need to set this to "220-240V.")

3. POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been

connected. Make sure the MASTER LEVEL knob is set to "zero" before turning it on.

4. SPEAKER OUTPUTS – Connect the speakers to these outputs using 1/4" cables.

5. MIC INPUT (XLR) – Connect a microphone to these inputs with an XLR cable.

6. LINE INPUT (1/4") – Connect line-level devices to these inputs with 1/4" TRS cables.

7. LINE INPUT (1/4") – Connect line-level devices to these inputs with 1/4" TS cables.

8. HI EQ (TREBLE) – Adjusts the high (treble) frequencies of the channel.

9. MID EQ (MID) – Adjusts the mid-range frequencies of the channel.

10. LOW EQ (BASS) – Adjusts the low (bass) frequencies of the channel.

11. AUX SEND 1 – Adjusts the channel audio (pre-fader) level that is sent to the MONITOR OUT and

PHONES output.

12. AUX SEND 2 – Adjusts the channel audio (post-EQ) level that is sent to the mixer's internal effects

processor or AUX OUT. Turn this up for the channels that you want effects applied to. You can use this

to apply effects to individual channels. (If you have an external device connected to the STEREO RTN

jack, the internal effects processor will be bypassed.)

13. PAN – Adjusts the (mono) channel's position in the stereo field.

14. BALANCE (CH 5/6 and 7/8) – Adjusts the balance between Channels 5 and 6 and Channels 7 and 8.

15. CHANNEL LEVEL – Adjusts the audio level on the channel.

1 2 3 4 5 6 7 8 9 ... 27 28

Pas de commentaire

Alto-professional MIXPACK Pro Manuel d'utilisateur Page 4