Alto-professional TS110A Manuel d'utilisateur télécharger pdf (Page 8)

SPECIFICATIONS

Output Power: 300 W Continuous RMS (235 W LF + 65 W HF)

600 W Peak (470 W LF + 130 W HF)

Active Crossover: 2.5 KHz

Max SPL @ 1m: 120 dB Continuous, 123 dB Peak

Frequency Range: 53 Hz – 20 kHz (@ -10 dB)

Frequency Response: 70 Hz – 19 kHz (+

3 dB)

Max Input Level: +18 dBu (input impedance: 15 kΩ)

Transducer Low: 10" (254 mm) woofer, 2" (51 mm) voice coil

Transducer High: 1" (25mm) exit with 1" (25 mm) neodymium compression driver

Horn Coverage: 80/100° H x 60° V nominal

Connectors: Mic/Line Input: two 1/4" TRS or XLR

Link Output: one XLR

Cabinet: Trapezoidal, with floor monitor capability. Injection molded, polypropylene

enclosure, with perforated steel grille

External Control: Volume, power on/off with LED, clip limiter with LED, ground lift

Protection: Over-excursion, thermal, driver

Power supply: 100-120 V or 200-240 V, 50/60 Hz

Inrush current at initial switch-on: 4.36 A

Inrush current after power supply interruption: 3.73 A

Mounting: Integrated pole-socket (36 mm dia.), one handle, four M10-threaded

sockets (2 top, 2 bottom)

Dimensions (H x W x D): 20.2" x 13" x 11.7" (513 mm x 330 mm x 297 mm)

Weight (speaker only): 26.6 lbs (12.1 kg)

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE

FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)

THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY

CAUSE UNDESIRED OPERATION.

www.altoprofessional.com

MANUAL VERSION 1.1

1 2 3 4 5 6 7 8

Pas de commentaire

Alto-professional TS110A Manuel d'utilisateur Page 8